Results of Research and Development
Analysis of the surface morphology and topography of pure aluminium machined using WEDM
Publication Year: 2018
MOURALOVÁ, K. KOVÁŘ, J. KLAKURKOVÁ, L. BEDNÁŘ, J. BENEŠ, L. ZAHRADNÍČEK, R.
COMPARING THE PERFORMANCE OF MICRO-END MILLS WHEN MICRO-MILLING OF ADDITIVE MANUFACTURED TI-6AL-4V TITANIUM ALLOY
Publication Year: 2018
RYŠAVÁ, Z. BRUSHI, S., PÍŠKA, M. ŽÍDEK, J.
Cutting Insert Wear Analysis Using Industry 4.0
Publication Year: 2018
PROKEŠ, T. MOURALOVÁ, K. KOVÁŘ, J. ZAHRADNÍČEK, R. ANDRŠ, O.
Design of Stirling Engine Operating at Low Temperature Difference
Publication Year: 2018
SEDLÁK, J. GAVAČ, A.
Design of the Tool for Pressing of Tarpaulin Grommets
Publication Year: 2018
ŘIHÁČEK, J. PODANÝ, K. HUDEČEK, M.
Effect of alloying elements on properties and structure of high chromium cast irons
Publication Year: 2018
KAŇA, V. ZÁDĚRA, A. KRUTIŠ, V.
Effect of Vibrations on Surface Quality in Advanced Ceramics Grinding
Publication Year: 2018
SÁMELOVÁ, V.
Effect of width of kerf on machining accuracy and subsurface layer after WEDM
Publication Year: 2018
MOURALOVÁ, K. KOVÁŘ, J. KLAKURKOVÁ, L. PROKEŠ, T.
End Mills with PCD Inserts Sharpened by Different Electrical Technologies
Publication Year: 2018
TRČKA, T. POLZER, A. SEDLÁK, J.
EVALUATION OF RESIDUAL STRESS IN CONDITIONS OF IRREGULAR INTERRUPTED CUT
Publication Year: 2018
ČEP, R. MALOTOVÁ, Š. KOUŘIL, K. ČEPOVÁ, L. KYNCL L. SAJGALIK, M. CZANOVA, T.
Experimental Investigation into Wear and Tool Life of Milling Cutter PVD Coated Carbide Inserts While Armox 500 Steel Hard Milling
Publication Year: 2018
MAJERIK, J. DUBOVSKÁ, R. JAMBOR, J. ČEP, R. KRATOCHVÍL, J. KOUŘIL, K.
Fatigue Behaviour of Powder Steel Specimens Made by Selective Laser Melting
Publication Year: 2018
POKLUDA, J. HORNÍKOVÁ, J. PÍŠKA, M. ŠANDERA, P.
Showed 241–255 from 2114 results