Publication detail

Determination of deformation resistance in tube flaring process

PETERKOVÁ, E. SAMEK, R.

Czech title

Stanovení deformačního odporu při rozšiřování konce trubky

English title

Determination of deformation resistance in tube flaring process

Type

journal article in Scopus

Language

en

Original abstract

The determination of the forming force required for manufacturing of the specified component is very important in practice. It is necessary to know value of the deformation resistance of the forming process for its theoretical finding. This paper presents a methodology for calculating of the total deformation resistance and subsequently of the forming force by using the theoretical equations. The method of the tube flaring was chosen for the research. The experiments were done on the testing tube samples from material 1.4301. These experiments were performed for comparing of the theoretical and real values of the forming force. The calculated values of forces differ slightly from those obtained experimentally. This difference lies in the use of the simplified input conditions and computational analysis such as material model obtained from tensile test of tubes, the chosen coefficient of friction and the simplified approach to calculation of the bending stress used in the theory of deep drawing.

Czech abstract

Stanovení potřebné velikosti tvářecí síly pro výrobu zadané součástí je velmi důležité pro praxi. Pro její teoretické určení je nutné znát velikost deformačního odporu daného procesu. Tento článek předkládá metodiku výpočtu celkového deformačního odporu a následně i tvářecí síly pomocí odvozených teoretických rovnic. Pro zkoumání byla vybrána metoda tváření konce trubky do tvaru kužele. Pro srovnání teoretické a reálné hodnoty tvářecí síly byly provedeny experimenty na trubkových vzorcích z materiálu 1.4301. Vypočtené hodnoty sil se trochu liší od hodnot získaných experimentálně. Tento rozdíl spočívá v užití zjednodušujících vstupních podmínek a výpočtových analýz jako je materiálový model získaný z tahové zkoušky trubek, zvolená hodnota koeficientu tření a zjednodušený přístup pro výpočet ohybového napětí užívaný v teorii hlubokého tažení.

English abstract

The determination of the forming force required for manufacturing of the specified component is very important in practice. It is necessary to know value of the deformation resistance of the forming process for its theoretical finding. This paper presents a methodology for calculating of the total deformation resistance and subsequently of the forming force by using the theoretical equations. The method of the tube flaring was chosen for the research. The experiments were done on the testing tube samples from material 1.4301. These experiments were performed for comparing of the theoretical and real values of the forming force. The calculated values of forces differ slightly from those obtained experimentally. This difference lies in the use of the simplified input conditions and computational analysis such as material model obtained from tensile test of tubes, the chosen coefficient of friction and the simplified approach to calculation of the bending stress used in the theory of deep drawing.

Keywords in Czech

rozšiřování konce trubky; deformační odpor; tvářecí síla; analytický model

Keywords in English

tube flaring test; deformation resistance; forming force; analytical model

Released

21.11.2016

Publisher

MM Science Journal

Location

Praha

ISSN

1805-0476

Volume

2016

Number

5

Pages from–to

1332–1337

Pages count

6

BIBTEX


@article{BUT131902,
  author="Eva {Peterková} and Radko {Samek},
  title="Determination of deformation resistance in tube flaring process",
  year="2016",
  volume="2016",
  number="5",
  month="November",
  pages="1332--1337",
  publisher="MM Science Journal",
  address="Praha",
  issn="1805-0476"
}