Detail publikace

Prediction of the Stamped Part Thinning Depending on Its Geometry and Blank Material

ŘIHÁČEK, J. PODANÝ, K. FALTÝNEK, F.

Anglický název

Prediction of the Stamped Part Thinning Depending on Its Geometry and Blank Material

Typ

článek v časopise ve Scopus, Jsc

Jazyk

en

Originální abstrakt

The paper deals with a design of new dimple geometry with a view to minimizing its thinning. In this case, three types of blank materials were analyzed, i.e. ferritic steel X2CrCuTi18, austenitic steel X5CrNi18-10 and austenitic steel X5CrNi18-10 with additional heat treatment. Thinning analysis for different dimple geometry and blank material is performed with a numerical simulation using finite element method in ANSYS software. To verify the accuracy of the numerical simulation, a practical stamping of the part with initial design and comparison between resulting thinning values, which is determined by ANSYS software and experimental microscopic measurement, is also performed.

Anglický abstrakt

The paper deals with a design of new dimple geometry with a view to minimizing its thinning. In this case, three types of blank materials were analyzed, i.e. ferritic steel X2CrCuTi18, austenitic steel X5CrNi18-10 and austenitic steel X5CrNi18-10 with additional heat treatment. Thinning analysis for different dimple geometry and blank material is performed with a numerical simulation using finite element method in ANSYS software. To verify the accuracy of the numerical simulation, a practical stamping of the part with initial design and comparison between resulting thinning values, which is determined by ANSYS software and experimental microscopic measurement, is also performed.

Klíčová slova anglicky

Numerical Simulation, Forming, Dimple, ANSYS, Finite Element Method

Vydáno

30.04.2019

Nakladatel

J. E. Purkyne University in Usti n. Labem

Místo

Ústí nad Labem

ISSN

1213-2489

Ročník

19

Číslo

2

Strany od–do

314–320

Počet stran

7

BIBTEX


@article{BUT156728,
  author="Jan {Řiháček} and Kamil {Podaný} and František {Faltýnek},
  title="Prediction of the Stamped Part Thinning Depending on Its Geometry and Blank Material",
  year="2019",
  volume="19",
  number="2",
  month="April",
  pages="314--320",
  publisher="J. E. Purkyne University in Usti n. Labem",
  address="Ústí nad Labem",
  issn="1213-2489"
}