Detail publikace

Mechanická odezva vývojových SiOC skel vůči vysokoteplotní expozici

HALASOVÁ, M. CHLUP, Z. STRACHOTA, A. ČERNÝ, M. DLOUHÝ, I.

Český název

Mechanická odezva vývojových SiOC skel vůči vysokoteplotní expozici

Anglický název

Mechanical response of novel SiOC glasses to high temperature exposition

Typ

článek v časopise - ostatní, Jost

Jazyk

en

Originální abstrakt

The presented work describes mechanical properties of materials prepared by the pyrolysis of polysiloxane resins. The polymeric precursors have different chemical composition. Materials under investigation are predetermined for high temperature resistant applications usually in composite form, i.e. accompanied by some reinforcement. Instrumented hardness tests were employed for material characterisation. The Vickers hardness, Martens hardness and indentation elastic modulus were the key parameters, determined either from the standard optical technique or load–indentation depth curves. The influence of mechanical properties on the monomers ratio was established. The exposition to the temperature between 1200 C and 1500 C in air was applied to observe damage caused by these severe conditions.

Český abstrakt

Práce popisuje mechanické vlastnosti materiálů připravených pyrolýzou polysiloxanových pryskyřic. Výchozím materiálem jsou polymerní prekurzory odlišných chemických vlastností. Zkoumané materiály jsou určeny pro vysokoteplotní aplikace obvykle v podobě kompozitu, tzn. že obsahují výztuž. Pro materiálové hodnocení byl použit test instrumentované tvrdosti. Vickersova, Martensova tvrdost a indentační modul pružnosti byly klíčovými parametry, určenými standartní optickou metodou, či ze závislosti napětí – indentační hloubka. Byl stanoven vliv poměru monomerů na mechanické vlastnosti. Dále bylo studováno poškození materiálu po jeho vystavení teplotám od 1200 do 1500 stupňů Celsia.

Anglický abstrakt

The presented work describes mechanical properties of materials prepared by the pyrolysis of polysiloxane resins. The polymeric precursors have different chemical composition. Materials under investigation are predetermined for high temperature resistant applications usually in composite form, i.e. accompanied by some reinforcement. Instrumented hardness tests were employed for material characterisation. The Vickers hardness, Martens hardness and indentation elastic modulus were the key parameters, determined either from the standard optical technique or load–indentation depth curves. The influence of mechanical properties on the monomers ratio was established. The exposition to the temperature between 1200 C and 1500 C in air was applied to observe damage caused by these severe conditions.

Klíčová slova česky

Tvrdost; Sklo; Mechanické vlastnosti; RTG

Klíčová slova anglicky

Hardness; Glass; Mechanical properties; X-ray

Rok RIV

2012

Vydáno

01.12.2012

ISSN

0955-2219

Ročník

32

Číslo

16

Strany od–do

4489–4495

Počet stran

7

BIBTEX


@article{BUT101122,
  author="Martina {Halasová} and Zdeněk {Chlup} and Adam {Strachota} and Martin {Černý} and Ivo {Dlouhý},
  title="Mechanical response of novel SiOC glasses to high temperature exposition",
  year="2012",
  volume="32",
  number="16",
  month="December",
  pages="4489--4495",
  issn="0955-2219"
}